Frankford DS-750 Digital Reloading Scale

This scale is all over the map, won't hold zero, recalibrate oftern and it still shows readings all over. For my load, I needed 41.8gn. I was using H4350 stick powder. I would get to 41.7gn, add one stick of powder it would jump to 41.9. Lift the tray off, put it back down and it shows 50.2. Remove 1 stick of powder, goes to 41.5.

I have used this scale to load hundreds of rounds. It's good for finding what your load is from your dispenser, but don't ask any more from it for that. It's incredibly slow to adjust and because of that, trickling up is an arduous task because it is so slow that you can overcharge quite easily. If you're shooting for 31gr for example, it will get to 39, and then if you don't wait like 10 seconds after you drop a kernel, you might go to 31.1. And then you have to dump a few kernels out and it will show you're back at 30.7. It is just all over the place with consistency. It will move .3gr between just picking up and setting your cup down without adding anything to it. I wouldn't recommend this scale for ANYTHING precision or small loads where .1gr can make a large difference. I cannot wait to not use this scale when my new one comes in

I bought this peace about 2 weeks ago and regret it .It's slow and not very accurate. Its faster on my beam scale..I do not recommend it...

I purchased this as a backup and it won’t measure correctly. I’ve had issues with it not reading correctly. I have replaced the batteries, kept it clear from any wind disruptions to get a precise measurement. I can place a charge weight on it, lift the pan off for a few seconds and place it back on and it will read .2 or .3 grains high or low. I can do this several times and maybe the second or third time it will finally read the initial weight. I should have taken the subpar reviews on this item a little more serious. Hate to be “that dude” who leaves a low review.

Great scale. Checked against my beam scale and it was dead on. It really speeds up powder measuring without sacrificing accuracy. The included aluminum pan is good as well. I would put this up against units 3 or 4 times the price. A++

I’ve had this scale about six weeks and use it measure powder charges. It doesn’t hold zero or +/- 0.1gn. It varies as much as +/- 0.4gn on zero and on the same powder charge in pan just by removing the pan and putting back on the scale. Changed batteries 4 times. Makes no difference. I used two different levels they read perfect in all directions. Recalibrate several times each use. Recheck zero between weighings. It checks out, remove pan to charge with powder, weighs what I want. Dump powder in brass. Check zero again and it is +/- 0.4gn so the charge I just dumped has to be redone. This happens way too often. I don’t trust this scale will not be using it again. It has gotten worse through use!

Been reloading alot of years. In all that time (and over 1M rnds) the scale I used the most is the DS 750. tried others and went right back.

I bought this unit about two years ago as a back up for my old school power scale. I have done several hundred hand loads with this scale and its perfect. Simple to CAL, just make sure the batteries are good and your ready to go